Extron-electronics SI 28 User Manual

User’s GuideSurface Mount Speakers68-1164-01Rev. A11 06SI 26 and SI 28

8SI 26 and SI 28 Speakers • InstallationInstallation, cont’dFigure 12 — Hook the speaker over the edges of the V-lock groove on the wall mount assembl

3. Turn on the audio source and any associated devices. Follow the manufacturers instructions to adjust the source and device settings as desired to

10SI 26 and SI 28 Speakers • Troubleshooting TipsTroubleshooting TipsService accessIn order to service the speaker it may be necessary to remove the f

Observed ProblemPossible Cause(s) Remedial Action1 Speaker easily lifted from mount assembly.Locking hex cap screw not tightened enough.Following the

12SI 26 and SI 28 Speakers • SpecificationsAudio/acoustic and electrical Speaker type ... 2-way, indoor/outdoor surfac

Extron’s WarrantyExtron Electronics warrants this product against defects in materials and workmanship for a period of five years from the date of pur

© 2006 Extron Electronics. All rights reserved.Extron Electronics, USA1230 South Lewis StreetAnaheim, CA 92805USA714.491.1500 Fax 714.491.1517Extro

SI 26 and SI 28 Speakers • PackagingPackaging InformationPart No.XXX-XXX-01Install 206W Ceiling Speaker33-XXXX-01 REV.Thick Single WallPackingBottom

SI 26 and SI 28 Speakers • Introduction1About the SI 26 and SI 28 SpeakersThe Extron System INTEGRATOR® SI 26 and SI 28 two-way surface mount speakers

SI 26 and SI 28 Speakers • Features2FeaturesDimensions: SI 26: 13.0" H x 8.5" W x 6.75" D (33.0 cm H x 21.6 cm W x 17.1 cm D)

InstallationInstalling the SI 26 or SI 28 SpeakerThe SI 26 or SI 28 can be mounted on a surface, such as a wall or post, or mounted in a bookcase, or

4SI 26 and SI 28 Speakers • InstallationInstallation, cont’d shown in figure 5 and tighten the hex cap screw to lock the plate in position. This make

Cut accesshole alongsidestud and feedwires though hole.Wall StudWall Mount AssemblyWallApproximate Studline Behind WallBend wire to lineup with access

Installation, cont’d6SI 26 and SI 28 Speakers • Installation7. Place the wall mount assembly against the wall, aligning the plate holes with those dr

Seismic Safety CableAttach line hereand secure.Anchor this end to a suitable secure point.Figure 10 — Attach a seismic safety cable to the rear of the