Extron electronics DTP HDMI 230 User's Guide download pdf (Page 13)

DTP HDMI 230 D Transmitter and Receiver • Installation and Operation 7

c RS-232/IR (Control) pass-through connector — Connect a serial communications

port to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232

communication (see RS-232 and IR connector wiring on page 12 to wire the

connector).

NOTE: The RS-232 connector can also transmit one-way modulated infrared (IR)

signals.

Transmitter Rear Panel

SIG

LINK

DTP OUT

POWER

12V

0.8 A MAX

DTP 230 D Tx

Figure 6. DTP HDMI 230 D Transmitter Rear Panel Connectors

a DC power input connector — Plug the included external 12 VDC power supply into

either this 2-pole connector (see Power supply wiring on page 11 to wire the power

connector) or the power input connector on the receiver (see b on the following page).

b Transmitter output port — Connect one end of the twisted pair cable to the

RJ-45 connector on the transmitter (see Connector and Cable Details on page 10 to

properly wire the RJ-45 connectors).

ATTENTION: Do not connect this device to a telecommunications or computer

data network.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

No comments

Extron electronics DTP HDMI 230 User's Guide Page 13