Extron electronics HFX 100 Rx User's Guide download pdf (Page 11)

DFX 100 • Panels and Cabling 5

Optical output connector — Connect one end of one multimode fiber optic cable (not

provided) into this LC connector. The other end connects into the LC input connector

on the DFX 100 Rx. The cable can be up to 984 feet (300 m) in length.

CAUTION:

• Possible Damage to Eyesight. The DFX 100 Tx outputs continuous laser

(Class 1 rated), which may be harmful and dangerous to the eyes; use with

caution. Do not look into the rear panel ﬁber optic cable connector or into the

ﬁber optic cable itself. Plug the attached dust cap into the optical transceiver

when the ﬁber optic cable is unplugged.

• Possible radiation exposure. Use of controls or adjustments or

performance of procedures other than those speciﬁed herein may result in

hazardous radiation exposure.

DFX 100 Rx Rear Panel

POWER

12V

1.0 A MAX

INPUT

OUTPUT

DFX 100 Rx

POWER

12V

1.0 A MAX

INPUT

OUTPUT

DFX 100 Rx

3 feet (0.91 m) DVI cable

Figure 5. DFX 100 Rx Rear Panel

12 VDC power input — Connect the provided 12VDC power supply to the front panel

captive screw connectors. When power is provided to the unit but there is no DVI input,

the front panel lights amber.

See Figure 4, the attention points, and the notes on page 4 before connecting the

power supply.

DVI-D output connector — Connect a DVI-D display device to this male connector.

NOTE: Although the cable is terminated with a DVI-I connector, the receiver is

compatible only with a single link DVI-D signal.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Extron electronics HFX 100 Rx User's Guide Page 11