Extron electronics DTP DVI 330 User's Guide download pdf (Page 11)

DTP HDMI 330 Tx/Rx Transmitter and Receiver • Installation and Operation 5

e Power input connector — Plug the included external 12 VDC power supply into

either this 2‑pole connector or the power input connector on the receiver (item

page 6). See Power supply wiring on page 8 to wire the connector.

NOTES:

• One power supply is included with the transmitter and normally can power

both units.

• If you have removed the ground jumpers (see Disconnecting the Ground

on page 11) because of ground potential differences, one DTP HDMI 330

unit cannot remotely power the other unit. Each unit requires a local power

supply.

Receiver Connections

DTP HDMI 330 Rx Rear Panel

Front Panel

DTP HDMI 330 Rx

RS-232

Tx Rx Tx RxG

POWER

12V

0.7A MAX

AUDIO

SIG LINK

DTP IN

OUTPUTS

OVER DTP

10 6 7

Figure 3. DTP HDMI 330 Rx Connectors

f DTP Input RJ-45 connector — Connect one end of the TP cable from the transmitter

output connector to this RJ‑45 female connector. Ensure the opposite end of this

cable is connected to the transmitter DTP Output RJ‑45 connector (see item d on the

previous page).

ATTENTION: Do not connect this device to a telecommunications or computer

data network.

NOTE: See TP cable termination and recommendations on page 7 to properly

wire the RJ‑45 connectors and for detailed NOTES.

Signal LED — Indicates the unit is receiving a valid signal on the DTP In connector.

Link LED — Indicates a valid link is established between the units on the DTP input

and output cable.

g HDMI output connector — Connect a display with an HDMI input port (or DVI input

port, with an appropriate adapter) to display the transmitted direct digital image.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

No comments

Extron electronics DTP DVI 330 User's Guide Page 11