Extron electronics DTP HDMI 301 User's Guide download pdf (Page 13)

Pin Assignments and Wiring

HDMI connector

Figure 5 defines the pinout for the HDMI connector.

Pin Signal

TMDS data 2+

TMDS data 2-

TMDS data 0–

TMDS clock- +5 V power

Hot plug detect

CEC control

Reserved

(NC)

TMDS data 1+ TMDS clock+

TMDS clock

shield

SDA

DDC / CEC

Ground

TMDS data 2

shield

Pin Pin Signal Signal

11 17

12 18

TMDS data 0-

TMDS data 0

shield

SCL

TMDS data 1-

TMDS data 1

shield

HDMI

Type A Receptacle

Type A Plug

18 2

182

Figure 5. HDMI Connector

To securely fasten an HDMI cable to a device:

1. Plug the HDMI cable into the panel connection (see figure 6).

Figure 6. Installing the LockIt Lacing Bracket

2. Loosen the HDMI connection mounting screw from the panel enough to allow the

LockIt lacing bracket to be placed over it. The screw does not have to be removed.

3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then

tighten the screw to secure the bracket.

CAUTION: Do not overtighten the HDMI connector mounting screw. The shield it

fastens to is very thin and can easily be stripped.

4. Loosely place the included tie wrap around the HDMI connector and the LockIt lacing

bracket as shown.

5. While holding the connector securely against the lacing bracket, use pliers or similar

tools to tighten the tie wrap, then remove any excess length.

DTP HDMI 301 • Installation and Operation 7

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Comments to this Manuals

No comments

Extron electronics DTP HDMI 301 User's Guide Page 13

Comments to this Manuals