Extron-electronics AVTRac End Ramp and Cable Pass-Through Kits User Manual download pdf

Extron

AVTrac

Cable Pass-Through Kit

The AVTrac Cable Pass-Through kit is a one-piece pass through transitional ramp that abuts a

hollow table leg, desk or lectern. Cables carried by the AVTrac pass through a hole in the furniture

and run on to connect to the appropriate device.

NOTE: The AVTrac Connectivity Box is not required as cables are routed through the metal

track and directly into the furniture.

Full details about installing the AVTrac system are

provided in the AVTrac User Guide, available at

www.extron.com).

1. Mark where the end ramp abuts the

furniture.

2. Drill a hole into the furniture. The hole

must be large enough for the cables to

pass through easily, but small enough to be

concealed by the end ramp kit.

3. Pre-drill 5/32 inches diameter holes in the

track and ramps.

4. Pre-drill holes 1.5 inches deep in the concrete

ﬂoor, using the drill bit provided.

5. Secure the track to the ﬂoor, using the provided masonry screws.

6. Run power and A/V cables from the wall, along the track and through the furniture. Connect

the cables as required.

7. Snap the cover track in place and cover the ramps with carpet to ﬁnish.

Rubber Strip (optional)

Aluminum

Cover Tr ack

Side Ramp

Hole Drilled in Furniture

Cable

Pass-Through

Ramp

68-1795-01 B

10 10

Extron

AVTrac

End Ramp Kit

End transition ramps are already

provided with all AVTrac system kits.

The ramps are now available as a

separate kit (part number 70-714-01)

for situations where only end ramps

are required to complete an existing

AVTrac installation.

Install the AVTrac system as described

in the AVTrac User Guide, which is

available at www.extron.com.

To add the end ramps to the system:

1. Place the end ramps in position abutting the end of

the track.

2. Pre-drill 5/32 inches diameter holes through the ramp.

3. Drill holes 1.5 inches deep into the ﬂoor, using the drill bit

provided.

4. Secure the ramps with the masonry screws provided.

5. Cover the ramps with carpet to ﬁnish.

End Ramps

68-1795-01 B 1

Summary of Contents

Page 1 - 68-1795-01 B

Extron® AVTrac® Cable Pass-Through KitThe AVTrac Cable Pass-Through kit is a one-piece pass through transitional ramp that abuts a hollow table leg, d

Comments to this Manuals

No comments

Extron-electronics AVTRac End Ramp and Cable Pass-Through Kits User Manual

Browse online or download User Manual for Hardware Extron-electronics AVTRac End Ramp and Cable Pass-Through Kits. Extron Electronics AVTRac End Ramp and Cable Pass-Through Kits User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Extron-electronics AVTRac End Ramp and Cable Pass-Through Kits