Extron-electronics CC 101P User Manual download pdf

Product Category

CC 101P • Installation Guide

Extron CC 101P Campus Communication Panel is a wall plate accessory to the CC 100C Audio Codec and works with the Extron

GlobalViewer Campus Communication Suite (GVCCS) system. It ts in a single opening Decora style wall plate.

The front panel has a Call button, an integrated microphone, and a monitoring LED indicator. When the Call button is pressed and

released, the GVCCS operator is notied of an incoming call. The “MIC ON” LED indicator lights up when the GVCCS operator is

monitoring the room.

The CC 101P has two contact closures, and a mono balanced line level audio out on the rear panel that can be connected to the

CC 100C. A recessed microphone gain potentiometer on the rear panel is used to adjust the microphone gain.

NOTE: Before installing this device, read the Extron Safety and Regulatory Compliances Guide, available at www.extron.com.

Installation and Cabling

NOTE: The installation of this device must be done in accordance with National Electrical Wiring Codes.

ATTENTION: Do not install the CC 101P in a re resistant rated wall or partition assembly.

ATTENTION: Ne pas installer le CC 101P dans un mur résistant au feu ou une cloison.

1. Using the mud ring or a junction box as a guide, mark the edges and cut out the material within the marked area.

NOTES:

• If installing a junction box, allow enough depth for the wall plate and cables, with consideration to the cable bend radius.

Do not bend the cables at 90 degrees.

• Conduit and conduit adapters should be used.

2. Either:

z Insert the mud ring into the opening, rotate the locking arms, and

secure

with the supplied screws,

z Insert the wall box and secure with nails or screws.

3. Run the power, contact in and contact out cables, and the line out cables

from the PoleVault switcher location, going behind the wall and to the

CC 101P location, then thread the cables through the mud ring or wall box

Rear Panel Connections

MIC ON

Extron

CALL

MIC

GAIN

+ –

12-15 VDC

IN G

CONTACT

OUT

+ –

LINE

OUTPUT

Front Panel

Features

Rear Panel

Connectors

Mic On LED

Microphone

Call button

Decora Faceplate

Mic Gain

Tone switch

Line Output

Contact Out

Contact In

Power

Decora

Faceplate

Extron

CC 101 P

Wall

Mud Ring

Cabling

MIC ON

Extron

CALL

Figure 1. CC 101P Front and Rear Panel Features

Figure 2. Installing the CC 101P in the Mud Ring

PRELIMINARY

1 2

Summary of Contents

Page 1 - PRELIMINARY

Product Category1CC 101P • Installation GuideExtron CC 101P Campus Communication Panel is a wall plate accessory to the CC 100C Audio Codec and works

Page 2 - CC 101P • Installation Guide

CC 101P • Installation Guide4. Connect the Line Output cable to the rear panel 3-pole captive screw connector (see G in figure 3), and to the Line In

Comments to this Manuals

No comments

Extron-electronics CC 101P User Manual

Browse online or download User Manual for Hardware Extron-electronics CC 101P. Extron Electronics CC 101P User Manual [fr]

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Extron-electronics CC 101P