Extron-electronics MLC 52 Series Quick Start Guide User Manual

MLC 52 SeriesMediaLink™ ControllerQuick Start Guide68-1184-01 Rev. D07 07

MLC 52 Series Quick Start Guide, cont’dMLC 52 Series • Quick Start Guide8Step 3Press the button on the MLC front panel that will store the IR code tha

9MLC 52 Series • Quick Start GuideStep 6When finished programming buttons, set configuration switch #1 on the rearpanel to Off. Verify that the comma

MLC 52 Series Quick Start Guide, cont’dMLC 52 Series • Quick Start Guide101 1 2 3 4 E ON 2 3 4 Tx IR OUT GND IR IN GND + 12V 1 1 2 3 4 E ON 2 3 4 Tx I

11MLC 52 Series • Quick Start GuideMLC 52 DISPLAYONPCOFF VOLVOLVIDEOOrder in which the buttons blink during data transferAfter each 17% of the data ha

MLC 52 Series Quick Start Guide, cont’dMLC 52 Series • Quick Start Guide126 feet (1.8 m) Part #70-335-01 5 1 9 6 Sleeve (Gnd) Ring Tip 9-pin D Conne

13MLC 52 Series • Quick Start GuidePowering offTo turn the projector/display off, press the Off button. The button blinks for4 seconds, then remains

© 2007 Extron Electronics. All rights reserved.Extron Electronics, USA1230 South Lewis StreetAnaheim, CA 92805800.633.9876 714.491.1500 FAX 714.4

This symbol is intended to alert the user of important operating and maintenance(servicing) instructions in the literature provided with the equipment

1MLC 52 Series • Quick Start GuideMLC 52 Series Quick Start GuideAbout the MLC 52 SeriesThe Extron MediaLink™ Controller 52 (MLC 52) provides infrared

MLC 52 Series Quick Start Guide, cont’dMLC 52 Series • Quick Start Guide2MLC 52 VC models with volume control faceplateThe two-gang sized MLC 52 IR VC

3MLC 52 Series • Quick Start GuideInstalling the MLC 52The MLC can be installed into a wall or furniture. Follow the instructionsappropriate to the

MLC 52 Series Quick Start Guide, cont’dMLC 52 Series • Quick Start Guide4Step 3Attach cables to the control connector on the MLC 52 rear panel.The por

5MLC 52 Series • Quick Start Guideb. Wire the RS-232 (Tx) port (RS models only). If you have an RS model andwant to control the projector via RS-232,

MLC 52 Series Quick Start Guide, cont’dMLC 52 Series • Quick Start Guide6 VOL/ MUTE 10V MPA 122 or MPA 181T Remote Port 10V 1 2 3 VOL MLC 52

7MLC 52 Series • Quick Start Guide Wall openingis flush withedge of box.MLC 52 MLC 52 DISPLAYOFF ON VIDEO VOL VOL PC Mounting the MLC 52 in a