Extron-electronics XTP DTP 24 Punch Down Jack User Manual download pdf

XTP DTP 24 Punch Down Jack • Setup Guide

The following tools are required to terminate the shielded XTP DTP 24 punch down connector:

Follow these instructions to terminate the connector:

1. Slide the rear case of the connector over the

cable. Push the case back at least 3 inches

(76 mm) to make room for the termination of the

cable.

2. Remove about 2 inches (50 mm) of the cable

jacket.

3. Fold down the braid over the cable jacket.

Remove the foil and mylar shielding (if present).

4. Note the color codes and pin numbers on the

sides of the connector. Follow the color code in

the table at right to wire the connector.

5. Untwist the wire pairs and hold the end of the

stripped cable jacket close to the back of the

connector. The length of the exposed wires in the

connector should not exceed 0.6 inch (see image

at right).

ATTENTION: Failure to position the

cable properly may result in crosstalk and

improper termination.

Slide Rear Case

over Cable

Strip Jacket 2"

Fold Braid over Jacket

and Remove Foil

Color-coded Label

w/ Pin Number

Color Code B

IDC Slots

21 45

Distance Between

Cable and Connector

0.6"

IDC

Position

T568B Wiring

IDC Numbers & Color Codes

White/Blue

T568B

Wire Colors

Blue

White/Orange

Orange

White/Green

Green

White/Brown

Brown

110-Style Punchdown Tool

(Provided)

Wire Cutter RJ-45 Tester

6. Position each wire into its respective IDC slot. Insert

the wires just far enough to hold them in the IDC slots.

1 2

Summary of Contents

Page 1 - Wire Cutter RJ-45 Tester

XTP DTP 24 Punch Down Jack • Setup GuideThe following tools are required to terminate the shielded XTP DTP 24 punch down connector:Follow these instru

Page 2 - 68-2370-50

7. Use the 110-style punchdown tool to push down each wire into the IDC slot. Push the punchdown tool until the wire is rmly secured at the bottom o

Comments to this Manuals

No comments

Extron-electronics XTP DTP 24 Punch Down Jack User Manual

Browse online or download User Manual for Hardware Extron-electronics XTP DTP 24 Punch Down Jack. Extron Electronics XTP DTP 24 Punch Down Jack User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Extron-electronics XTP DTP 24 Punch Down Jack