Extron electronics MTP DA4 User Manual download pdf

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

specifications before connecting the

product to the power source.

MTP DA4 and DA8 • Setup Guide

This guide provides basic instructions for an experienced installer to set up and

Disable

Mute

(Default)

Enable

Mute

Serial

Audio

(Default)

operate an Extron MTP DA4 or DA8 distribution amplier.

Pre-installation — Jumpers

See the gure at the right or see “Termination and Mute Jumpering” in the

MTP DA4 and MTP DA8 User Guide for more information.

NOTE: The jumpers have no effect when the DA is part of an MTP CV/SV

series, or VTT001/VTR001 system.

Jumper J3

This sets the DA to properly terminate RGB video as well as the audio (default) or serial portion of the input signal.

Jumper J9

This sets the DA to always pass the audio or serial link regardless of the contact closure mute status (default). It can also be set

to mute the audio or serial link when its video mute function is activated.

Installation

Step 1 — Mounting

Turn off or disconnect all equipment power sources and mount the MTP DA as required. A mounting example is shown below).

See “Mounting” in the user guide for more mounting options.

Use 2 mounting holes on

opposite corners.

1/2 Rack Width False Front

Face Plate

(2) 4-40 x 3/16" screws

6" Deep Rack Shelf

MTP DA SERIES

Figure 1. Mounting the MTP DA

Step 2 — Input from the Transmitter

Terminate a TP cable as shown in gure 3. Connect the cable into a MTP transmitter

1234

A/V INPUT

A/V OUTPUTS

Wire color

White-green

Green

White-orange

White-blue

Orange

White-brown

Brown

Wire color

T568A T568B

White-orange

Orange

White-green

White-blue

Green

White-brown

Brown

Blue Blue

12345678

RJ-45

Connector

Insert Twisted

Pair Wires

Pins:

and into the AV input connector.

Step 3 — Outputs to the Receivers

Terminate up to four or eight (depending on model) TP cables as shown in the gure to the

right. Connect the cables into the DA AV output ports and into receivers that are compatible

with the transmitter.

NOTES:

• The inputs and outputs should be terminated using the same standard on both

ends of the cable.

• Only use the TIA/EIA T568A standard when using Enhanced Skew-Free™ AV

cable.

1 2

Summary of Contents

Page 1 - MTP DA4 and DA8 • Setup Guide

IMPORTANT:Go to www.extron.com for the complete user guide, installation instructions, and specifications before connecting the product to the power s

Page 2 - Operation — Mutes

68-975-50 Rev. D01 13Extron Headquarters+800.633.9876 Inside USA/Canada Only Extron USA - West Extron USA - East+1.714.491.1500 +1.919.850.1000+1.71

Extron electronics MTP DA4 User Manual

Browse online or download User Manual for Network switches Extron electronics MTP DA4. MTP DA4 and DA8 • Setup Guide

Summary of Contents

More documents for Network switches Extron electronics MTP DA4

Comments to this Manuals

Extron electronics MTP DA4 User Manual

Browse online or download User Manual for Network switches Extron electronics MTP DA4. MTP DA4 and DA8 • Setup Guide

Summary of Contents

More documents for Network switches Extron electronics MTP DA4

Comments to this Manuals

Related products and manuals for Network switches Extron electronics MTP DA4