Extron electronics SCP 100P User Manual download pdf (Page 10)

System 5

• SCP 100 User’s Manual • Extron

Operation

SCP 100 Operation

The SCP 100 panel replicates the normal operations of the front

panel. The function names are the same. As stated earlier, Setup

(or Config) Mode operations cannot be done from the SCP 100.

The IR Remote port receives IR 40 signals and sends them to the

System 5 by the cable. Signals from other IR devices are blocked

at the System 5.

Any “learned” IR commands that are stored in the System 5

memory will be transmitted from the System 5’s IR emitter or the

optional IR Broadcaster when the associated button is pressed on

the SCP 100 panel, just as it will when that same front panel

button is pressed.

Figure 2-1. SCP 100 panel controls are similar to those on the front panel.

Room Button and LED

This button and LED work with the relay contact connections

provided on the rear panel of the System 5. The button can

activate/deactivate a room condition, such as turn lights on/off and

raise/lower a viewing screen. The LED indicates when the

condition exists. Exactly how the feature is used depends upon

the user-defined application and what is connected to the “Relay”

connector on the rear panel.

2-1

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Extron electronics SCP 100P User Manual Page 10