Extron-electronics YCS SW6 MX User Guide User Manual download pdf (Page 8)

YCS SW6 MX • Installation and Operation

Installation and Operation, cont’d

2-6

Attaching remote control devices

The remote connector provides a way to control the switcher by

using contact closure devices such as the following:

• Extron’s IR 20 infrared remote control (see “Installing an IR 20

infrared remote control” below).

• Remote contact closure (see “Remote Contact Closure

Operation” on page 3-6).

• RS-232 port and a host computer (see “Serial Communication”

on page 3-2).

Installing an IR 20 infrared remote control

The IR 20 remote control system includes the following

components:

• IR 20 remote control (hand-held remote control unit)

• IR detector with 6-foot (1.8 meter) cable and RJ-11 connector

• IR 20 adapter with 3-foot (0.9 meter) cable and RS-232 T

connector

• External 9VDC power supply for adapter.

To install an IR 20 infrared remote control, do the following:

1. Attach the 9-pin T plug on the IR 20 adapter to the remote

connector on the rear panel of the switcher (figure 6).

Figure 6 — Installing the IR 20 infrared remote

control

2. If a host RS-232 device is also being attached, connect its

RS-232 plug to the unused side of the adapter’s RS-232

T connector.

3. Plug the IR detector’s male plug into the IR 20 adapter’s

RJ-11 female connector.

4. Connect the 9VDC power supply to the IR 20 adapter.

5. Position the IR detector (limited by its cable length) in the

best position to receive infrared light from the IR 20 hand-

held remote control.

Operation

Front panel features

Figure 7 — Front panel features

Power LED — Lights to indicate that power is supplied to the

switcher.

Input selection LEDs — Light to indicate the active input.

Input selection buttons — Allow you to select the input to be

displayed.

Selecting an input

The YCS SW6 MX switcher is a video decoder/encoder/

switcher with both composite and S-video outputs. It separates

composite video into S-video format, or it combines S-video

(YC) input signals into composite video format. Both formats

are available as outputs, regardless of the selected input type.

To select an input using the front panel buttons, press the button

for the desired input. The LED for the selected input turns on.

When a new input is selected, switching does not occur until the

next vertical blanking interval of the current input signal. The

output is then switched to the new input.

2-7

12345678

IR 20

Remote Control

IR Detector

RS-232

T Connector

IR 20 Remote Control

Adapter

IR-20

YCS SW6 MX

PC Computer

1 2

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Extron-electronics YCS SW6 MX User Guide User Manual Page 8

Comments to this Manuals

Related products and manuals for Accessories for video Extron-electronics YCS SW6 MX User Guide