Extron-electronics MTP 15HD RS Series User Guide Rev. C User Manual Page 1

User GuideMTP 15HD RS SeriesTwisted PairHigh Resolution Video and Serial Link MTP Transmitters and Receivers68-2205-01 Rev. C04 14

VideoFormatPre-Peak OffPre-Peak OnMax. Distance (High Quality) Max. Distance (Variable Quality)Composite, S-video, Component800'(245 m)1000&apo

Installation and OperationThis section provides information on: • Installation and Operation Overview • Front Panel Features • Transmitter Rear Panel

Front Panel FeaturesSee figure 2 and the following descriptions to identify the front panel features on the transmitter and receiver.MTP RL 15HD RS rec

E EDID select rotary switch — The rotary switch selects specific pre-programmed or user-recorded EDID settings. Position 0 of this 16 position rotary

J Delay (skew adjustment) control (SEQ model only) — This control delays the selected red, green, or blue video signal by up to 62 nanoseconds. The d

Transmitter Rear Panel FeaturesSee figure 3 and the following descriptions to identify the rear panel features on the MTP T 15HD RS transmitter.OUTPUTI

E Pre-Peak switch — The Pre-Peak switch alters the twisted pair signal output to correct for long cable runs (see the table on page 4 for suggested s

Receiver Rear Panel FeaturesSee figure 6 and the following descriptions to identify the rear panel features on the MTP RL 15HD RS receiver.INPUTBUFFERE

Power Supply Wiring and GroundingFigure 7 shows how to wire and ground the connector.CAUTION: Failure to follow these instructions may result in mino

ATTENTION: • This product is intended to be supplied by a Listed Power Unit marked "Class 2" or "LPS", rated 12 VDC, maximum 1.0

Safety InstructionsSafety Instructions • EnglishWARNING: This symbol, , when used on the product, is intended to alert the user of the presence of u

Twisted Pair Cable TerminationFigure 8 details the recommended termination of twisted pair cables with RJ-45 connectors in accordance with the TIA/EIA

Skew Delay CompensationCAT 5, 5e, and 6 cable can lead to registration errors between the red, green, and blue video signals. Pair skew can be measure

MTP 15HD RS Series • Installation and Operation 16EDID ConfigurationThe MTP 15HD RS transmitter can either record EDID from a display device, or a pre

MountingThis section outlines the various mounting options available for the MTP 15HD RS Series transmitters and receivers: • Tabletop Placement • Und

Rack Mounting ProcedureThese units can be mounted with optional rack systems listed on the website (see www.extron.com). To mount the unit on a rack s

Extron Headquarters+1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 FAX +

FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC rul

ContentsIntroduction ... 1About this Guide ... 1About the MTP Tran

IntroductionThis section gives an overview of the user guide and describes the MTP 15HD RS series of transmitters and receivers. Topics covered inclu

The RS-232 portion of the twisted pair link: • Can be bidirectional in a one-receiver system; that is, the receiver can receive commands from the tran

Transmission DistanceThe maximum distance is determined by the frequency and resolution of the signal that is input to the transmitter. The table on p