Extron electronics 60-870-23 User's Guide download pdf (Page 16)

Cabling and Setup

To ensure proper operation, the transmitter, receiver, USB host, and USB peripherals must

be connected properly and in the sequence described below. Connections are the same

regardless of which models (Extender, Extender AAP or Decora) are being installed.

NOTE: If the USB host is capable of powering the transmitter (0.4 A maximum), the

external supply for the transmitter is not required.

Power down the USB host PC or laptop that will be connected to the transmitter and all

peripherals and devices that will be connected to the receiver.

USB USB

HUB

POWER

12V

1.0A MAX.

LINK

DO NOT

CONNECT

TO LAN

HOST

POWER

12V

0.4A MAX.

DO NOT

CONNECT

TO LAN

LINK

Ground

+12 VDC

External Power

Supply (optional)

(12 VDC, 1 A )

External Power

Supply (required):

Rack Mount: 12 VDC, 1 A

AAP: 12 VDC, 2 A

Decora: 12 VDC, 1 A

Ground

+12 VDC

Laptop

(USB Host)

Keyboard

(USB Peripheral)

Four USB 2.0 compatible female Type A

connectors provide +5 VDC at up to

500 mA to connected USB peripherals.

NOTE: If the USB host is capable of supplying power,

the transmitter supply is not required.

The receiver must have a power supply connected.

Transmitter Receiver

UTP or STP CAT5 or better cable.

Te rminate both ends identically, in accordance with

either the TIA/EIA T 568A or the TIA/EIA T 568B

wiring standard.

Figure 7. USB Extender Connection Guide with Two External Supplies

If an external supply powers the transmitter:

1. Connect twisted pair cable between the USB Extender transmitter and receiver.

2. Connect one included power supply to the USB Extender receiver and one to the

transmitter, then apply power to both. The Power LEDs on the receiver and transmitter

light.

Additionally, with both units powered, the Link LEDs light to indicate connectivity on the

twisted pair link.

3. Connect a Type A-B USB cable (Type A male to mini Type B male for AAP and Decora Tx)

from the USB host to the USB Extender transmitter.

4. Apply power to the USB host. After the host has booted, the transmitter Host LED lights

to indicate communication between the host and transmitter. Shortly after, the Host LED

on the receiver lights, then blinks to indicate the host is communicating with the hub

controller (USB Extender receiver).

5. Connect USB peripherals (keyboard, mouse, scanner, printer, or other USB devices) to

the receiver. As each peripheral is recognized by the host, the respective USB hub port

LED on the receiver front panel lights.

USB Extenders • Installation and Operation 10

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Comments to this Manuals

No comments

Extron electronics 60-870-23 User's Guide Page 16

Comments to this Manuals

Related products and manuals for Console extenders Extron electronics 60-870-23