Extron-electronics Flexible Conduit Kit User Manual download pdf

The Extron

Flexible Conduit Kit for is a 6-foot (1.8 m) length of electrical conduit with three

7.5-foot (2.3 m), 14-gauge power wires connected to a mounting plate compatible with

Extron Cable Cubby

. The kit provides a simple means to replace the permanent or IEC power

cord of the Extron Cable Cubby with conduit where required by local codes.

UL Guidelines

The Underwriters Laboratories (UL) guidelines listed below pertain to the installation of the

ﬂexible conduit kit into an Extron Cable Cubby.

WARNING: Installation and service must be performed by a qualiﬁed electrician only.

1. This unit is not to be used beyond its rated voltage range.

2. This unit must be wired to a UL-listed distribution box. The installer is responsible for obtaining and installing the box.

3. This unit must be installed in accordance with the National Electrical Code and with all local codes.

Removing the Old Cable

NOTE: If the power box is installed in a Cable Cubby, remove the Cable

Cubby from the table in which it is installed, if necessary, and

remove the power box from the Cable Cubby. See the Cable

Cubby User’s manual.

US/Domestic power boxes have power cords that are

permanently connected to the power box.

International power boxes have standard IEC power

connectors.

1. Unplug any device(s) plugged into the Cable Cubby power box and

disconnect power.

2. Remove and retain the four Phillips head screws on the side of the

power box and remove the side plate (shown at right).

3. Remove the two Phillips head screws on the power input connector

plate on the back (bottom) side of the power box and gently pull the

plate back as far as the wires inside the power box will allow (below right).

4. Cut the cable exiting the power input connector plate as indicated at

right.

• US/Domestic power box — Extend the power cord and cut it

about 8 inches (20 cm) from the front of the power box.

NOTE: Ensure that you cut the power cord after the point

where the separate wires from the front plate outlets

are joined in heat shrink.

• International (IEC) power box — Extend the power cord and cut

the wires as close to the back side of the power IEC connector as

possible.

5. Strip away 1.5 inches (3.8 cm) of the outer jacket (US/Domestic power

box) and 0.5 inches (1.3 cm) of the individual wires’ insulation.

6. Gently pull the three cut wires out of the side of the power box.

Remove 4 scre

and side plate.

Remove 2 screws.

Remove the power input

plate.

Flexible Conduit Kit Installation Guide

1 2

Summary of Contents

Page 1 - Removing the Old Cable

The Extron® Flexible Conduit Kit for is a 6-foot (1.8 m) length of electrical conduit with three 7.5-foot (2.3 m), 14-gauge power wires connected to a

Page 2 - 68-734-01

Installing the Replacement Cable1. Place the conduit plate from the Flexible Conduit Kit on the bottom side of the power box. Insert the provided Ph

Comments to this Manuals

No comments

Extron-electronics Flexible Conduit Kit User Manual

Browse online or download User Manual for Hardware Extron-electronics Flexible Conduit Kit. Extron Electronics Flexible Conduit Kit User Manual [fr]

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Extron-electronics Flexible Conduit Kit