Extron-electronics GLI 2000 5BNC Setup Guide User Manual

Browse online or download User Manual for Hardware Extron-electronics GLI 2000 5BNC Setup Guide. Extron Electronics GLI 2000 5BNC Setup Guide User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
GLI 2000 5BNC • Setup Guide (continued)
Step 3 — Connect Outputs
b
Connect the video source outputs to the 5 BNC inputs of the GLI 2000 5BNC.
Example of a Typical GLI 2000 Application
Computer
Extron
GLI 2000 5BNC
Ground Loop Inhibitor
Projector
H
V
INPUT
OUTPUT
R
G
B
GLI 1000 5BNC
Extron
RGB 109xi
Interface
BUFFERED LOCAL
MONITOR OUTPUT
INPUT
H. SHIFT
RGB 109 xi
VGA INTERFACE W /ADSP
ID PIN 4
ID PIN 11
68-811-01
Rev. B
08 12
GLI 2000 5BNC • Setup Guide
This card provides quick start instructions for an experienced
installer to set up and operate the GLI 2000 5BNC. The
GLI 2000 5BNC is a heavy duty passive ground loop inhibitor,
eliminating hum bars and common mode noise created
by improper equipment grounding.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and rack mount the GLI 2000
5BNC device using four GLI 2000 5BNC 4 - 40 x 3/16 inch screws as required.
Step 2 — Connect Inputs
a
Connect the video source inputs to the 5 BNC outputs of the GLI 2000 5BNC.
RGBS
RGBHV
RsGsBs, RGsB, YUV, Y/C, Composite
RG B
H
V
RG B
H
V
RG B
H
V
NOTE: The H and V channels on the GLI 2000 5BNC have
a bandwidth of 200 MHz rather than 425 MHz, and
should not be used for high resolution signals.
INPUT
OUTPUT
R
GLI 2000 5BNC
GROUND LOOP INHIBITOR
G
BH
V
1
2
IMPORTANT:
Refer to www.extron.com for the
complete specifications.
Extron USA Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron USA - West: +1.714.491.1500 FAX: +1.714.491.1517
Extron USA - East: +1.919.850.1000 FAX: +1.919.850.1001
© 2012 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
Page view 0
1

Summary of Contents

Page 1 - GLI 2000 5BNC • Setup Guide

GLI 2000 5BNC • Setup Guide (continued)Step 3 — Connect OutputsbConnect the video source outputs to the 5 BNC inputs of the GLI 2000 5BNC.Example of a

Comments to this Manuals

No comments