Extron electronics MTP 15HD RS Series User's Guide download pdf (Page 13)

Transmitter Rear Panel Features

Figure 4 shows an MTP T 15HD RS transmitter, which has all of the connectors and other

features that are on either transmitter in the MTP 15HD RS series.

OUTPUT

INPUT

POWER

12V

.5A MAX

Tx Rx

RS-232

MONITOR

PRE-PEAK

OFF

MTP T 15HD RS

NOTE: A “C7” label is affixed to

transmitters designed for

STP201 or CAT 7 cable.

Figure 4. Transmitter Rear Panel

Power connector — Plug the included external 12 VDC power supply into this 2-pole

captive screw connector. Wire the connector as shown in gure 9 on page 13.

CAUTION: Read the notes, cautions, and warnings in the "Power Supply

Wiring" section on page 13 before wiring the connector.

Input video connector — Connect a computer video source to this 15-pin HD

connector for high resolution video input (see ﬁgure 5).

15 11

610

Female

Figure 5. 15-pin HD Connector

NOTES: • Input only sync signals (no video signals) on the sync pins (13 and 14).

• For component video, use the R (R-Y) and R return pins (pins 1 and 6),

G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return pins

(pins 3 and 8).

• For S-video, use the R, R return (C-chroma), G, and G return (Y-luma)

pins.

• For composite video, use the G pin and the associated return pin. For

additional genlocked video signals, use the R, B, and associated return

pins.

Monitor connector — Connect a video monitor to this 15-pin HD connector for

buffered, high resolution video loop-through.

MTP 15HD RS Series • Installation and Operation 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

No comments

Extron electronics MTP 15HD RS Series User's Guide Page 13