Extron electronics MTP 15HD RS Series User's Guide download pdf (Page 9)

Receiver Jumpering

By default, the receiver is unidirectional, conﬁgured to send serial data from the transmitter

to the receiver, only. If the system has only one receiver, this jumper can be repositioned to

enable bidirectional communication as follows:

1. If applicable, disconnect all cables, remove the receiver from its installation location, and

remove any mounting brackets installed.

2. Remove the two screws from either side of the receiver (four screws total) and lift the

top cover off of the receiver (see ﬁgure 2 below).

3. Locate jumper JMP1 on the serial data (top) board and shift the jumper to bridge the

jumper block (see ﬁgure 2 below).

4. Place the top cover back into place.

5. Reinstall the four screws removed in step 2. If any mounting brackets were removed in

step 1, put them back into position as you reinstall the screws.

6. If applicable, reinstall the receiver and reconnect all cables.

INPUT

BUFFERED

OUTPUT

POWER

12V

.5A MAX

MT P R L 1 5HD RS

1 2 3 4 5 6

H SYNC +

V SYNC +

C SYNC

SOG

VIDEO

END UNIT

RS-232

Jumper bloc

k JMP1

inside box.

JMP1

JMP2

JMP3

Unjumpered for

Unidirectional

Jumpered for

Bidirectional

Remove 4 screws,

lift top straight up.

Figure 2. Opening the Receiver and Setting the Directional Jumpers

MTP 15HD RS Series • Introduction 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Comments to this Manuals

No comments

Extron electronics MTP 15HD RS Series User's Guide Page 9

Comments to this Manuals

Related products and manuals for Receiver Extron electronics MTP 15HD RS Series