Extron-electronics CVEQ1, CVEQ1 WM, CVEQ1 AAP User Manual download pdf (Page 9)

CVEQ1 Series • Installation, Setup, Operation

Installation, Setup, Operation, cont’d

CVEQ1 Series • Installation, Setup, Operation

2-5

CVEQ1

AUDIO INPUT

VIDEO INPUT

L R

AUDIO INPUT

VIDEO INPUT

L R

CVEQ1 AAP

CV E Q1 WM

L AUDIO IN

R AUDIO IN

VIDEO IN

CVEQ1

Front Panel

CVEQ1 AAP

Front Panel

CVEQ1 WM

Front Panel

Power indicator LED — This

LED lights amber when the

line driver receives power. It

lights green when the line

driver receives power and an

active signal.

Video input connector — Use

a coaxial cable to connect a

composite video source to this

female BNC connector.

Audio input connectors

— Connect an audio source

using these female RCA-style

connectors for left and right

unbalanced stereo audio

input. The male

plugs should be

wired as shown at

right.

Faceplate screws (CVEQ1 WM and CVEQ1 AAP only) — These

screws fasten the line driver’s faceplate to the rest of the line driver.

Do not remove these faceplate screws while the line driver is

attached to the wall/furniture or the detached line driver may

fall down into the electrical box.

To replace the faceplate with a customized faceplate:

1. Set the line driver in an accessible place (do not attempt to

replace the faceplate while the line driver is installed in a wall or

furniture), and remove the faceplate screws.

2. Remove the hex nut that fastens the video input BNC to the plate.

3. Fasten the new faceplate to the line driver with the faceplate

screws.

4. Replace the video input BNC’s hex nut and tighten it.

Front Panel Features and Cabling

Audio RCA tip-sleeve

connector_052501.eps

Tip

(Signal)

Sleeve (Gnd)

If attaching the wall box to wood, use four #8 or #10 screws

or 10-penny nails. A minimum of ½ inch

(1.3 cm) of screw threads must penetrate the wood.

If attaching the wall box to metal studs or furniture, use

four #8 or #10 self-tapping sheet metal screws or machine

bolts with matching nuts.

8. Set the gain and equalization, and cable and test the

line driver before fastening it into the wall box. The

adjustments and cables will be inaccessible after

installation. See “Top/Side Panel Features and

Adjustments” in this chapter for details.

2-4

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

Extron-electronics CVEQ1, CVEQ1 WM, CVEQ1 AAP User Manual Page 9

Comments to this Manuals

Related products and manuals for Accessories for video Extron-electronics CVEQ1, CVEQ1 WM, CVEQ1 AAP