Extron-electronics YCS SW2 A User Guide User Manual download pdf (Page 11)

YCS SW2 A • Installation and Operation

Installation and Operation, cont’d

2-8

YCS SW2 A • Installation and Operation

2-9

Two tools are included with the PMK 450 kit:

• A set-screw hex wrench

• A security screw hex wrench

To projector-mount the YCS SW2 A using the PMK 450,

1. Unscrew the front and rear plates and the security screws

from the sides of the PMK 450.

2. Slide the top and bottom plates apart.

3. Loosen the four pipe collar set screws to allow the top

plate to move freely along the pole.

4. Ensure that the mounting pipe is installed with the cable

access hole facing the rear, away from the projector screen.

5. Slide the top plate up the pipe until the pipe collar is

positioned just above the cable access hole. Ensure the rear

of the top plate is facing to the rear, in the same direction as

the cable access hole in the pipe.

FRONT

REAR

Pipe Collar and

Set Screws

Figure 2-8 — Positioning the top plate on the pipe

6. Level the top plate and secure it by fully tightening the set

screws. At least three screws must come in contact with

the pipe.

7. Route the cables for the devices to be mounted so that the

cables exit the pipe through the cable access hole.

4. Repeat steps 2 and 3 on the other side of the YCS.

5. Hold the unit with the attached brackets against the

underside of the table or other furniture. On the mounting

surface, mark the location of the bracket’s screw holes.

6. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)

deep in the mounting surface at the marked screw

locations.

7. Insert #8 wood screws into the four pilot holes. Tighten

each screw into the mounting surface until slightly less

than 1/4" of the screw head protrudes.

8. Align the mounting screws with the slots in the brackets

and place the unit against the surface, with the screws

through the bracket slots.

9. Slide the unit slightly forward or back, then tighten all four

screws to secure it in place.

Projector mounting using the PMK 450

The Extron PMK 450 Multi-Product Projector Mounting Kit (part

#70-618-02 or #70-618-03) can accommodate multiple Extron

products of various sizes and their power supplies.

Rear Plate (1)

Pipe Collar (1) and

Set Screws (4)

Security Screw (2)

AC Power Cord

Access Slot

S-VI

Bottom Plate (1)

Filler Plate (1)

Front Plate (1)

Top Plate (1)

Extron

YCS SW2 A

Transcoding

Switcher

Figure 2-7 — Components of the Extron PMK 450 kit

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments

Extron-electronics YCS SW2 A User Guide User Manual Page 11

Comments to this Manuals

Related products and manuals for Audio accessories Extron-electronics YCS SW2 A User Guide