Extron electronics 14400 Setup Guide download pdf (Page 9)

10 FOX Matrix 320x and FOX Matrix 14400 • Installation 11FOX Matrix 320x and FOX Matrix 14400 • Installation

Power connectors — Plug the switcher into two grounded AC

sources.

NOTE: For reliability, connect the Redundant power cord to

either an uninterruptible power source or to a power source that

is completely independent from the primary power source.

Primary and Redundant power supply LEDs —

Green — Indicates that the associated power supply is operating

within normal tolerances.

Red — Indicates that the associated power supply is operating

outside the normal tolerances or has failed (see Removing and

Installing a Power Supply Module on page 25).

Fiber optic I/O board LED indications

On the ber optic I/O boards, the input and output LEDs on the

transceivers provide useful indications of the status of the lasers and the

reclocking function (see the table below).

OUT

Deﬁnition

Output LED

indication

Input LED

indication

Deﬁnition

Reclocked at 4.25 Gbps

On On

Reclocked at 4.25 Gbps

Not reclocked, laser off,

or no signal

Off Off

Not reclocked or no

signal

Non-4G signal present or

not reclocked

Fast blink Fast blink

Non-4G signal present or

not reclocked

Front Panel

FOX MATRIX 320x

FIBER OPTIC DIGITAL MATRIX SWITCHER

POWER SUPPLY

PRIMARY 1

REDUNDANT 1

PRIMARY 2

REDUNDANT 2

STATUS

CONFIG

AACC

Figure 6. Front Panel Conﬁguration Port, FOX Matrix 320x

FOX MATRIX 14400

CONFIG

FIBER OPTIC DIGITAL MATRIX SWITCHER

POWER SUPPLY

PRIMARY

REDUNDANT

BBCC

Figure 7. Front Panel Conﬁguration Port, FOX Matrix 14400

Configuration port (FOX Matrix 320x) — If desired, connect control

system or computer to the front panel Configuration (USB) port. Use

a standard mini USB B cable.

Configuration port (FOX Matrix 14400) — If desired, connect a

control system or computer to the front panel Configuration (RS-232)

port. Use an optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable.

Indicator LEDs —

Primary and Redundant Power Supply LEDs —

Green — Indicates that the associated power supply is operating

within normal tolerances.

Amber (FOX Matrix 320x only) — Indicates that AC power is

disconnected or the power supply has been removed.

Red — Indicates that the associated power supply is operating

outside the normal tolerances or has failed see Removing and

Installing a Power Supply Module on page 25) to replace the

power supply.

Status LED (FOX Matrix 320x only) —

Green — Indicates that the controller board is operating normally

and that the temperature and backplane voltages are all within

normal tolerances.

Red — Indicates that either the controller board has failed or that

temperature or backplane voltages are outside of acceptable

levels.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Comments to this Manuals

No comments

Extron electronics 14400 Setup Guide Page 9

Comments to this Manuals

Related products and manuals for Recording Equipment Extron electronics 14400