Extron-electronics CVEQ1, CVEQ1 WM, CVEQ1 AAP User Manual download pdf (Page 12)

CVEQ1 Series • Installation, Setup, Operation

Installation, Setup, Operation, cont’d

CVEQ1 Series • Installation, Setup, Operation

2-11

Mounting the CVEQ1 WM

The CVEQ1 WM must have output cables connected before it

is installed in a wall or furniture. Secure the CVEQ1 WM to the

wall box as shown below.

Installation Cable

Cable Clamp

ll Stud

CVEQ1 WM Install.eps

Mounting the CVEQ1 WM into a wall box

Mounting the CVEQ1 AAP

The CVEQ1 AAP and any other adapter plates must be attached

to a device’s faceplate or an AAP wallplate and cabled before the

device or wallplate is installed in a wall or furniture. The screws

needed for installing the CVEQ1 AAP are built into its front

panel, so no additional screws are needed.

1. Insert the CVEQ1 AAP’s screws through the holes in the

faceplate or AAP wallplate. Secure the line driver to the

faceplate or wallplate with the provided captive washers

and #4-40 nuts.

#4-40 Nut w/ Captive

Washer

CVEQ1 AAP w RGB 568 installation.eps

4-gang Wall Box

RGB 568

CVEQ1 AAP

RGB 568

Mounting the CVEQ1 AAP to an interface

or wallplate and into a wall box

2. Follow steps 3 through 8 in the Quick Start Guide at the

front of this manual.

2-10

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

No comments

Extron-electronics CVEQ1, CVEQ1 WM, CVEQ1 AAP User Manual Page 12