Extron electronics VoiceLift Operations Instructions download pdf (Page 48)

Installing and Mounting the Receiver, cont’d

VoiceLift

™

Microphone • Installing and Mounting the Receiver

5-4

PRELIMINARY

• VLC 102 Charging Station

• VLP 102 pendant microphone (additional)

The following diagrams show examples of some possible secondary receiver

placements and the resulting coverage:

Receiver and one secondary

receiver in an odd-shaped room

Receiver and one secondary receiver

in a long room

Receiver and three secondary receivers

in a large room, or a room with dark

walls, obstructions, and/or windows

Installation Overview

The installation procedures are outlined in this section. For detailed descriptions

and illustrations of these procedures, refer to the VoiceLift Microphone Installation

Guide.

Stage 1: Installing the receiver base and housing

Installing in a drop ceiling

1. Cut a 2" to 3" hole in the ceiling tile in which the receiver will be mounted.

2. Align the center of the receiver housing with the hole in the ceiling tile.

3. If needed, attach a conduit to the receiver back plate.

Observe all local and national building and safety codes to ensure that the

installation meets all regulatory codes.

4. Attach the Z-bracket to the end of the screw on the back side of the ceiling tile.

Replace the ceiling tile.

5. Set the Mix DIP switch to Off and the Tone DIP switch to On (VLR 102

primary receiver only).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 63 64

No comments

Extron electronics VoiceLift Operations Instructions Page 48