Extron electronics A-4 User Manual download pdf (Page 12)

VSC 150 • Installation and Operation

Installation and Operation, cont’d

Setting Up Genlock and

Vertical Interval Switching

A genlock (black burst generator) device can be connected

to the VSC 150 to synchronize it with other system compon-

ents for seamless vertical interval switching between sources.

Vertical interval switching setup

For vertical interval switching (to allow clean switching

between signals from several devices during the vertical

blanking period of each signal), a composite sync signal can

be applied at the Genlock In connector, and also passed to

another device via the Genlock Out connector.

2-13

posite video and one other), but not the local monitor.

ON — The output is in PAL format.

OFF — The output is in NTSC format.

Size the image to fill the screen

1. Press the Size button on the front panel.

2. Rotate the vertical and horizontal Centering/Pan/Size

rotary controls to adjust the vertical and horizontal

size. Observe the picture on screen as you adjust the

controls. The Min/Max LED will light red when the

minimum or maximum limit of a control is reached.

The size feature affects both display outputs, but local

monitor loop-out is not affected. The size function

remains active for 8 seconds after the rotary controls

become inactive. The rotary controls then default to

the standard centering and pan functions.

3. Press the Size button again to turn the size feature off.

4. Center the picture by rotating the vertical and

horizontal Centering/Pan/Size rotary controls.

5. Repeat steps 1 through 4 as needed.

Select the filtering levels

1. Press the horizontal, vertical and encoder filtering

controls to select the filtering levels that give the best

picture sharpness and the least amount of flickering.

The LEDs next to each control will light to indicate the

selected level of filtering.

If the filters are set before the image size is adjusted,

you must set the filters again after adjusting the

image size.

Mac-HV/VGA cable connector pin assignments

The illustration below shows the pin locations on the 15-pin

connectors at opposite ends of the Mac-HV/VGA cable that

is used for connecting the computer to the VSC 150.

VGA (15-pin HD) and Mac (15-pin D) connector

pin locations

The table below lists signals and their pin assignments for

both the VGA (15-pin HD) and Mac (15-pin D) connectors

of this cable.

VGA Pin Function Mac Pin

1 Red video 2

2 Green video 5

3 Blue video 9

4 ID bit 4

5 ID bit 8

6 Red ground 1

7 Green ground 6

8 Blue ground 13

9 Not used —

10 Composite & vertical sync gnd 11, 14

11 ID bit 7

12 ID bit 10

13 Horizontal sync 15

14 Vertical sync 12

15 ID bit/composite sync 3

2-12

Optimizing the Image

After you have installed the scan converter, follow the

procedures in this section in sequence. This will help you

configure the scan converter for the best settings for your

display environment.

Select the output standard

1. Select the output standard with the PAL Out DIP

switch. This switch affects both display outputs (com-

D15 Pin Locations

Male

915

HD15 Pin Locations

Male

11 15

106

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Comments to this Manuals

No comments

Extron electronics A-4 User Manual Page 12

Comments to this Manuals

Related products and manuals for Network switches Extron electronics A-4