Extron electronics PoleVault Systems PVS 300 Installation Guide download pdf (Page 28)

2. — Pull the Cables (at the input locations)

The following cables need to be installed:

• CAT 5 cables for signal transmission from the

AV wall plates to the PVS 305SA IP

NOTES:

• For PVT RGB D IP Plus four CAT 5

cables (two for video input and two

for LAN) are needed, and for PVT RGB

D wall plates, two CAT 5 signal cables

for each input are needed.

• Maximum distance from the

PVS 305SA to the Wallplate is 100 feet.

The optimum distance is between

50 and 75 feet. Minimum distance is

15 feet.

• CAT 5 cables supplied are terminated

to the TIA 568A standard. Other CAT 5

cables can be used if they are TIA 568A

or 568B standards and terminated to

the same standard at both ends.

• CAT 5 cables (included) for MLC network

connection.

• PoleVault switcher communication cable from

the MediaLink controller (MLC PW/RS-232/VC,

50 feet, part number 26-626-50)

• Projector communication cables from the

MediaLink controller (IR Serial Comm, 50 feet,

part number 26-621-50)

a. Drill cable pathways through any obstructions

(for example, wall caps, fire-breaks, or

horizontal studs).

b. Label the CAT 5 signal cables at both ends with

the supplied labels.

c. Pull the cabling through the wall from the ceiling

space down to the location of the transmitters

and other wall devices, and out through the

openings.

TIP: Secure cables with cable clamps to

provide strain relief.

RGB #1A

NOTE:

Fasten the colored section to the cable

first, then wrap the clear section around it.

Use the supplied labels for clear cable

identication during installation.

Signal Cable Label color

RGB 1A (Input 1 RGB) Orange

RGB 1 B (Input 1 RGB) Orange

RGB 2A (Input 2 RGB) Yellow

RGB 2B (Input 2 RGB) Yellow

RGB 3A (Input 3 RGB) Magenta

RGB 3B (Input 3 RGB) Magenta

RGB 4A (Input 4 RGB) Light Green

RGB 4B (Input 4 RGB) Light Green

Video 3 (Input 3 Composite Vid) Dark Green

Video 4 (Input 4 Composite Vid) Red

Pull the cables at each location.

PoleVault IP Systems • Installation — Stage 2 (Wallplates and MLC)24

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Comments to this Manuals

No comments

Extron electronics PoleVault Systems PVS 300 Installation Guide Page 28

Comments to this Manuals

Related products and manuals for Network switches Extron electronics PoleVault Systems PVS 300