68-1466-01 Rev. B11 10FOX Tx/Rx AVUser GuideFiber OpticsFiber Optic Extender
Panel Features and ConnectionsThis section of the user guide describes: Front panel features Rear panel features and connectionsFOX Tx/Rx AV Front
FOX Tx/Rx AV Rear Panel ConnectionsFigure 3 (below) shows the rear panel features of the FOX Tx AV. The FOX Rx AV rear panel is identical.FOX Tx AVY/V
CAUTION: Always use a power supply supplied by or specified by Extron. Use of an unauthorized power supply voids all regulatory compliance certificati
To input or output a composite signal, use a single BNC male connector to the Y/VID receptacle on the back panel of the unit.When both the BNC connect
i RS-232 connections — The Remote RS-232 connections (see the figure at right) allow the transmitter and receiver units to be configured using SIS comm
Daisy Chain CapabilityFOX Rx AV receivers have a loop-out mode that allows a signal to be passed along a daisy chain of to up to ten receivers, with a
ConfigurationThis section of the user guide provides information about: RS-232 Ports RS-232 Control of Tx and Rx Units SIS Commands Control Pro
As an alternative to the front panel TRS port, the RS-232 Remote port, on the rear panel, uses three connectors in a 5-pole captive screw connector.F
RS-232 Control of Tx and Rx UnitsWhen the FOX Tx/Rx AV is configured by RS-232 commands, some commands are processed by the transmitter and others are
SIS CommandsIntroduction to SISSIS commands consist of a string (one or more characters per command field). Commands do not require any special charact
This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipmen
X@ — Color, tint, contrast, or brightness adjustment (0 to 127)X# — Auto Memory, blanking, or audio mute status0 = disabled 1 = enabledX$ — Output vid
Command and Response Table for SIS CommandsCommand ASCII Command(host to unit)Response(unit to host)Additional descriptionInput video formatSpecify in
Command ASCII Command(host to unit)Response(unit to host)Additional descriptionOutput video formatSpecify output setting6*X$# SynX$]Sets format of out
Command ASCII Command(host to unit)Response(unit to host)Additional descriptionAudio output levelSet to consumer level40*0# Lvl0Sets audio output to c
Command ASCII Command(host to unit)Response(unit to host)Additional descriptionInformation RequestGeneral informationI1LinkX#•2LinkX#•VidX#•AudX#•X1!•
SIS Command Validity TableIf only one fiber optic channel is enabled, the ability to configure the system through SIS commands is limited by the lack of
Starting the ProgramStart the Extron FOX Extender control program as follows:1. Set up and power on the units as described in Power Input on page 5.
Status areaThe Status area provides visual indications of the connection status:Figure 14. Status AreaNOTE: Only link 1, connecting the Tx port of th
Memory Preset areaThe Memory Preset area provides tools to save and recall memory presets:Figure 15. Memory Preset AreaSelect a Preset Number from the
Advanced Configuration area Link 2/Daisy Chain Mode — Provides radio buttons to choose the mode for the receiver’s Tx port. If it is connected to the t
FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rule
SpecicationsNOTES: The FOX AV consists of a transmitter (FOX Tx AV) and a receiver (FOX Rx AV) with one or two fiber optic cables linking the two unit
Video input — transmittersNumber/signal type ... 1 component (Y, R-Y, B-Y), S-video, composite videoConnectors ...
Control/remoteSerial control ports on each unit (transmitter and receiver)Control ... 1 RS-232, 3.5 mm captive scre
Reference InformationThis section of the user guide provides information about: Included Parts Optional AccessoriesIncluded PartsIncluded parts Re
Optional AccessoriesAccessory Part numberPMK 350 70-563-0xPMK 200 70-077-04RSU 129 1U, 9.5 inch rack shelf kit 60-190-01RSB 129 1U, 9.5 inch rack shel
MountingThis section describes the mounting options for the FOX Tx/Rx AV Tabletop Mounting Rack Mounting Under-desk Mounting Through-desk Moun
Under-desk MountingMount the FOX Tx/Rx AV under furniture, using the optional Extron MBU 125 under-desk mounting kit (part number 70-077-01). Follow t
Extron® WarrantyExtron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of pur
Extron USA - WestHeadquarters+800.633.9876Inside USA/Canada Only+1.714.491.1500+1.714.491.1517 FAXExtron USA - East+800.633.9876Inside USA/Canada Only
ContentsIntroduction ... 1About the FOX Tx/Rx AV ... 1FOX Tx/Rx AV Features ..
FOX Tx/Rx AV • Contents vi
IntroductionThis user guide contains information about the Extron® FOX Tx/Rx AV family of signal transmitters and receivers, with information on how
Digitized signal transmission — Ensures perfect image quality. The non-linearity of the fiber components does not affect signal quality. Light can be d
Picture and audio adjustments — Available picture adjustments include color, tint, contrast, and brightness. Audio adjustments include input gain and
Comments to this Manuals