Extron-electronics Fox Tx_Rx AV User Guide User Manual download pdf (Page 29)

Advanced Conﬁguration area

Link 2/Daisy Chain Mode — Provides radio buttons

to choose the mode for the receiver’s Tx port. If it is

connected to the transmitter, the link may be enabled

or disabled. Alternatively, the port may be connected to

another receiver with the Daisy Chain mode enabled.

Auto Memory — May be switched on or off, using

radio buttons. When Auto Memory is on, previously

saved values such as color, tint, contrast, and brightness

are applied whenever the vertical ﬁeld rate of the input

changes.

Auto Image — Returns the video adjustment settings

of color, tint, contrast, and brightness back to their

default values (64).

Test Patterns — Allow the user to select one of

three built-in test patterns (color bars, grayscale, or

alternating pixels), which help calibrate the display

device. When Off is selected, the receiver outputs the

video signal from the source device.

Audio Adjustment area

Audio Gain/Attenuation — Provides a click and drag slider

control to select the input audio gain or attenuation value,

from -18 dB to +10 dB in 1.0 dB increments.

NOTE: The transmitter converts the input signal into a

proprietary signal type, which passes through

link 1 to the receiver. The receiver converts the

signal back to the required signal type. This allows

the input signal to be transcoded to meet the

requirements of the output device.

Audio Output Level — Provides radio buttons to allow a

choice between consumer level (-10 dBV) or professional level

(+4 dBu) for the audio output.

Firmware for FOX Tx/Rx AV

Firmware can be downloaded onto the unit from the Extron

website (www.extron.com).

CAUTION: The transmitter and receiver require different

ﬁrmware and must both be upgraded

separately.

FOX Tx/Rx AV • Conguration 23

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

No comments

Extron-electronics Fox Tx_Rx AV User Guide User Manual Page 29