Extron-electronics VGA -Show Me- Cable Setup Guide User Manual

Browse online or download User Manual for Hardware Extron-electronics VGA -Show Me- Cable Setup Guide. Extron Electronics VGA -Show Me- Cable Setup Guide User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
VGA “Show Me” Cable • Setup Guide
The Extron VGA “Show Me” Cable is an accessory for Extron VSW 2VGA A Series and
SW VGA Ars Series switchers. It provides video and audio signal pass-through connection
and a Share button for remote input selection. This guide provides instructions to set up
and operate the VGA “Show Me” Cable.
Features, Installation, and Operation
Features
SHARE
SHARE
End View
Male 15-pin HD
(VGA connector)
Stereo Audio Input
(unbalanced; female 3.5 mm TRS)
Share Button
Stereo Audio Output
(unbalanced; male 3.5 mm TRS)
End View
Male 15-pin HD
(VGA connector)
Top Vie
wT
op View
To
Source
Device
(input)
To
Switcher
(output)
1
2
3
Installation
1. Connect the input end of the VGA “Show Me” Cable to the output of the laptop or
source device.
2. Connect the output end of the VGA “Show Me” Cable to an Extron VSW 2VGA A
switcher (input 1 only) or an Extron SW VGA Ars Series switcher.
3. If desired, use an optional Extron mini audio cable (part number 26-571-01) to connect
the audio output of the source device to the audio input on the VGA “Show Me” Cable.
Operation
Input selection (Share) button — Pressing this button creates a momentary contact
closure to short pin 5 of the 15-pin HD connector to ground. This triggers the connected,
compatible Extron switcher to select the device connected to the VGA “Show Me” Cable as
the active input. Signals on all pins other than pin 5 are passed through.
NOTES:
• Make sure the switcher is configured for use with the VGA “Show Me”
Cable or the VSW I AAP, which is similar to the “Show Me” cable. See the
switcher user guide for configuration details.
• The Extron EDID 101V EDID Emulator is not compatible with this cable because
the “Show Me” cable pin 5 signal is not passed through the EDID 101V.
Continued on the other side Continued on the other side
Page view 0
1 2

Summary of Contents

Page 1 - Operation

VGA “Show Me” Cable • Setup GuideThe Extron VGA “Show Me” Cable is an accessory for Extron VSW 2VGA A Series and SW VGA Ars Series switchers. It provi

Page 2 - Switchers

VGA “Show Me” Cable • Setup Guide (Continued) VGA “Show Me” Cable • Setup Guide (Continued)68-2214-50 Rev. D 03 1268-2214-50 Rev. D 03 12Extron He

Comments to this Manuals

No comments