Extron electronics 14400 Setup Guide download pdf (Page 14)

20 FOX Matrix 320x and FOX Matrix 14400 • Remote Control 21FOX Matrix 320x and FOX Matrix 14400 • Remote Control

NOTE: You must ping the FOX matrix switcher as shown in

step 5 for the IP address change to take place. The response

should show the new IP address, as shown in the following

figure.

5. Execute a ping command by entering “ping” followed by a space and

the new IP address at the command prompt. For example:

ping 10.13.197.7

C:\>ping 10.13.197.7

Pinging 10.13.197.7 with 32 bytes of data:

Reply from 10.13.197.7: bytes=32 time<10ms TTL=128

Ping statistics for 10.13.197.7:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms

NOTE: You can reconnect using either Telnet or a Web browser

to verify that the update was successful.

6. After verifying that the IP address change was successful, enter and

issue the “arp –d” command at the DOS prompt. For example:

arp –d 10.13.197.7 removes 10.13.197.7 from the ARP table

arp –d* removes all static IP addresses from the ARP table.

Loading the Start-up Page

NOTE: If your Ethernet connection to the matrix switcher is

unstable, try turning off the proxy server in your Web browser. In

Microsoft Internet Explorer, click Tools > Internet Options >

Connections > LAN Settings, uncheck the Use a proxy

server... box, and then click OK.

1. Start the Web browser program.

2. Click in the Address eld.

3. Enter the Matrix IP address in the Address eld.

NOTE: 192.168.254.254 is the factory-specified default IP

address

4. Press the keyboard <Enter> key. The switcher checks to see if it is

password-protected.

If the switcher is not password-protected, it checks and

downloads the HTML start-up page. The switcher is ready for

operation via HTML remote control.

If the switcher is password-protected, it downloads the Enter

Network Password page.

NOTE: A User name entry is not required.

5. Enter the appropriate administrator or user password in the Password

eld and click OK.

The switcher downloads the HTML start-up page (see ﬁgure 9, on

the next page). The switcher is ready for operation via HTML remote

control.

NOTE For details on operating the switcher via HTML pages,

see the "HTML Operation" section in the FOX Matrix 320x and

FOX Matrix 14400 User Guide.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments

Extron electronics 14400 Setup Guide Page 14

Comments to this Manuals

Related products and manuals for Recording Equipment Extron electronics 14400