Extron-electronics DVI 201 User Guide User Manual download pdf (Page 11)

1U Universal Rack Shelf

Figure 3. Mounting the Transmitter or Receiver on a Universal Rack Shelf

Furniture mounting

Under-furniture mounting

The unit can be mounted under a horizontal surface using an optional MBU 125 under-

desk mounting kit (part #70-077-01). Mount the unit under a desk or table as follows:

1. Remove feet from the bottom of the DVI 201 unit if installed.

2. Secure the under-desk mounting brackets to the transmitter or receiver with the four

machine screws provided in the mounting kit (ﬁgure 4).

Figure 4. Under-Desk Mounting

3. Hold the transmitter or receiver with attached brackets against the underside of the

desk or other furniture. Mark the location of holes for screws on the desk.

4. Drill 1/4-inch (6.4 mm) deep, 3/32-inch (2 mm) diameter pilot holes in the table or

desk at the marked screw locations from the underside or inside (the concealed side)

of the furniture, where the transmitter or receiver will be located.

5. Insert the four wood screws into the pilot holes. Fasten each screw into the

installation surface until just less than 1/4 inch of the screw head protrudes.

6. Align the installed screws with the slots in the mounting brackets, and place the

transmitter or receiver against the surface, with the screws through the bracket slots.

7. Slide the transmitter or receiver slightly forward or back, then tighten all four screws

to fasten it in place.

DVI 201 • Installation and Operation 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Extron-electronics DVI 201 User Guide User Manual Page 11