Extron-electronics DVI 201 User Guide User Manual download pdf (Page 20)

Connections

Transmitter Connections

The wall-mountable transmitter is in an enclosure that can be mounted in UL standard

wall boxes with Decora-style face plates. The rack-mountable transmitter is in a quarter

rack width enclosure.

Figure 13 shows the front panel of the DVI 201 A D Tx. Figure 14, on the next page,

shows the rear panel of both DVI 201 Tx models.

DVI 200 Tx Series

DVI INPUT LOCAL OUTPUT

DVI 201 Tx Front Panel

DVI 201 A D Tx Front Panel

INPUT

RS-232

PASS THRU

DVI

AUDIO L+R

Figure 13. DVI 201 Tx Front Panel Connectors

DVI Input connector — Connect a DVI cable between this port and the DVI

output port of the digital video source. See DVI connector pin assignments for pin

assignments.

Local output (DVI 201 Tx ([non-Decora] only) — If desired, connect a DVI

monitor for local monitoring of the input digital image. See DVI connector pin

assignments for pin assignments.

NOTE: In a system where the local output is not used, ensure that you power up

the end display ﬁrst before the video source. Route the DDC to the remote

end (see the DDC Route DIP switch [item

, in Operation]).

DVI 201 • Installation and Operation 16

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

No comments

Extron-electronics DVI 201 User Guide User Manual Page 20