Extron-electronics DVI 201 User Guide User Manual download pdf (Page 15)

PMK 350 mounting

Mount the receiver to a PMK 350 bracket as follows:

1. Remove the front and rear plates from the PMK 350 (ﬁgure 8), using an Extron

Tweeker or a #2 Phillips screwdriver. Retain the screws to reattach the plates.

Extron

PMK 350

Multi-product Pole

Mount Kit

Cover Sheet

Front Plate

Rear Plate

U-bolt

L-shaped

Bracket

Contoured

Base

Extron

Power Supply

Extron

Quarter-rack

Sized Product

Figure 8. PMK 350 Projector Mounting a Receiver

2. If necessary, remove the feet from the bottom of the receiver.

3. Secure the receiver to one side of the mounting tray, using two of the supplied

4-40 x 3/16-inch screws in opposite (diagonal) corners.

4. If power supply is connected to the receiver, use the two included tie wraps to strap

the power supply to the bracket.

5. Place the PMK 350 around the projector ceiling mounting pole (ﬁgure 8).

6. Assemble the U-bolt and the following parts in the following order (ﬁgure 9):

a. Pass the legs of the U-bolt through the slotted holes on the mount plate ﬂange.

b. Place the legs around the projector pole.

c. Pass the legs through the holes in the contour base.

NOTE: The pole ﬁts snugly into the depression in the center of the contoured

base.

d. Pass the legs through the holes in the L-shaped bracket.

NOTE: The supplied U-bolt ﬁts a typical (1.5-inch to 2.0-inch diameter) ceiling

pole.

U-bolt

Slotted Hole

in PMK Tray

L-shaped

Bracket

L-shaped

Bracket Screws

Contoured

Base

Ceiling

Pole

Mount Plate

Flange

Figure 9. Hanging the Tray on the Pole

DVI 201 • Installation and Operation 11

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Comments to this Manuals

No comments

Extron-electronics DVI 201 User Guide User Manual Page 15

Comments to this Manuals

Related products and manuals for Accessories for video Extron-electronics DVI 201 User Guide