Extron-electronics MSG0808 User Manual download pdf (Page 29)

MSG Matrix Switchers • Windows-based Control Program 4-7

VIS Enable

The current state of VIS (Vertical Interval Switching) is indicated by the presence or

absence of a checkmark next to VIS Enable on the Options menu. If a checkmark

appears, VIS is enabled. If a check mark does not appear, VIS is disabled. To toggle

VIS on or off, click VIS Enable with your mouse pointer.

Vertical interval switching requires a Genlock signal from a blackburst

generator or similar device.

Enable Response

The current state of the view response option is indicated by the presence or

absence of a checkmark next to Enable Response on the Options menu. If a check

mark appears, you will be able to view responses from the switcher when using

terminal communication (see Using Terminal Comm below). If a checkmark does

not appear, you will not be able to view responses from the switcher. To toggle the

view response option on or off, click Enable Response with your mouse pointer.

Using Terminal Comm

The Terminal window is used to view ICS100 commands as they are sent to the

switcher, and to view responses as they are received from the switcher. To use the

Terminal window, click on Terminal Comm from the Options menu. The Terminal

window opens.

In addition to viewing commands that are sent and received from the ICS100

Control Program, the Terminal window also allows you to save macro commands

or a communication session and recall it for repeated or future use. Refer to ICS100

Control Program Help for additional information on terminal communication.

Resetting the unit

1. From the Options menu, click on Reset Unit. A pullout menu appears.

2. To partially reset the switcher (restore all parameters to factory default, except

input volume settings) select Partial Reset from the pull out menu.

3. To fully reset the switcher (restore all parameters to factory default) select Full

Reset from the pull out menu.

ICS100 Control Program help

For information about program features, you can access the help program from

within the ICS100 Control Program, click on the Help tab on the main screen, then

select Help from the drop-down menu.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 53 54

No comments

Extron-electronics MSG0808 User Manual Page 29