Extron-electronics MSG0808 User Manual download pdf (Page 49)

MSG Matrix Switchers • Reference Information

B-3

Installing Custom Engraved Nameplates

Custom engraved input and output nameplates are available, by special order, for

the front panel of the MSG matrix switchers. Attachment screws come pre-installed

on the panel and permit easy installation of the optional nameplates. Contact your

Extron Sales Representative for specifications and prices.

Installing the custom nameplates

1. Using an Allen wrench, remove the nameplate mounting screws for either the

input or output group.

2. Hold the custom engraved nameplate in place on the front panel of the MSG

matrix switcher, aligning the holes in the plate with the screw holes in the

front panel.

3. Insert a mounting screw into each end of the nameplate and tighten with the

Allen wrench.

Figure B-2 — Installing a custom engraved nameplate

UT SE

LEC

MSG Series Matrix Switcher

INP

UT S

ELECT

TAK

BLA

PRE

SET

DIO

VID

LEVEL SELE

Engraved Nameplate

1 2 ... 44 45 46 47 48 49 50 51 52 53 54

No comments

Extron-electronics MSG0808 User Manual Page 49