Extron-electronics DVI 201 User Guide User Manual download pdf (Page 12)

Through-furniture mounting

The transmitter or receiver can be mounted through a desk or other furniture using an

optional Extron MBD 129 through-desk mounting kit, part #70-077-02. Mount the

transmitter or receiver through a desk or table as follows (ﬁgure 5):

Figure 5. Through-Desk Mounting

1. Loosely attach the mounting brackets to the transmitter or receiver using the four

machine screws and washers supplied with the mounting kit.

2. Hold the transmitter or receiver against the inside of the surface through which it will

be mounted. Mark the four screw holes and the table material to be removed on the

inside of the surface to which you are mounting the device.

3. Remove the table material. Test the ﬁt by inserting the front of the device through the

hole. If necessary, use a rasp or coarse ﬁle to enlarge the hole.

4. Drill four pilot holes, each 3/32-inch in diameter by 1/4 inch deep, where you made

marks.

5. Using the provided four wood screws, secure the brackets to the mounting surface.

6. Slide the transmitter or receiver up and down in the mounting brackets until the face

of the transmitter or receiver is at the desired height. Tighten the screws that secure

the brackets in place.

If the screws are inaccessible to a screwdriver:

a. Mark the location of the brackets relative to the screws.

b. Remove the transmitter or receiver from inside the furniture.

c. Tighten the screws.

d. Replace the unit inside the surface (step 5).

DVI 201 • Installation and Operation 8

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

No comments

Extron-electronics DVI 201 User Guide User Manual Page 12