Extron-electronics DVI 201 User Guide User Manual download pdf (Page 14)

NOTE: The PMK 300 has a hole in the bottom plate that allows the projector pole

to be inserted through the center of the plate (ﬁgure 7), rather than outside

of the plate (ﬁgure 6). To install the PMK 300 in this conﬁguration, slide

the bracket up from the bottom of the pole before the projector is installed

on the pole.

U-Bolt

Extron

PMK 300

Multi-product Pole

Mount Kit

Bracket

Brace

Figure 7. Projector Pole on the Inside

4. Place the contoured bracket brace against the pole and opposite the back plate. The

pole should ﬁt snugly into the depression in the center of the bracket brace.

5. Place the U-bolt around the ceiling pole. Insert the two legs of the U-bolt through the

round holes on the contoured bracket brace and then through the slotted holes on

the mounting plate on the bracket.

NOTE: The supplied U-bolt ﬁts a typical (1.5 inch to 2.0 inch diameter) ceiling pole.

DVI 201 • Installation and Operation 10

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

No comments

Extron-electronics DVI 201 User Guide User Manual Page 14