Extron-electronics TLE 350 Setup Guide User Manual download pdf

Before connecting the TLP 350CV to a

power source, refer to the TLP 350CV user

guide, which is available at

www.extron.com.

TLP 350CV and TLE 350 • Setup Guide

Overview

The Extron TLP 350CV 3.5-inch Cable Cubby

TouchLink

™

touchpanel and TLE 350 enclosure provide AV connectivity using

convenient pullout cables. The TLP 350CV also provides simple and versatile conguration and control for a range of IPLink

control systems via an Ethernet connection, using a required IP Link controller, a touch screen, and 10 customizable buttons.

Video and audio input is provided by two BNC connectors.

NOTE: The network output must connect via a network switch, hub, or router to an Ethernet LAN or the Internet, with

an Extron IP Link controller on the same network. Suggested controllers include IPL T S series (for example, IPL T S4),

IPL250, IPL T CR48, IPLTSFI244, or IPCP series.

The rst four pages of this guide provides basic instructions for experienced installers to mount either the TLP 350CV or the

TLE350. The last four pages show initial conguration for the TLP350CV. For reference material and full instructions about

conguring the touchpanel, see the TLP 350CV User Guide, which is available on the Extron website (www.extron.com).

Planning

 Before making any cuts, select the best location for the

TLP350CV or TLE 350.

 Ensure that the edge that opens on the lid is oriented correctly.

 Ensure there is enough space for all the system cables and

components, including cable retractors, if they are to be

installed.

 Decide on the method for cutting a hole in the table:

z Hand router and template

z CNC wood router

z Jigsaw and paper template

 Verify that you have the correct template or dimensions.

 Check all relevant regulations.

z Ensure the installation complies with local, state, and

national building and electrical codes.

z Ensure the installation complies with the Americans with

Disabilities Act or other accessibility requirements.

Tools Required for Installation

Safety Glasses

Phillips Screw Driver

Tape Measure

Vacuum Cleaner

1/4" Hex Nut Driver

Marking Pen

Square

Included Parts

With Power

Module

Without Power

Module

AC Power Module* 1 0

Pass-through AAPs

†

4 4

Blank AAPs 3 5

1-space bracket kit 0 0

2-space bracket kit 2 3

3-space bracket kit 1 1

NOTES:

* Inside the US, the TLP 350CV may be purchased with or without an AC power module. If a power module is

required for the TLE 350, it must be purchased separately.

Outside the US, see the Extron website to purchase an AC power module that is suitable for your location.

† Active or Passive AAPs must be purchased separately (see the Extron website).

Table Clamps

Zip Ties

#4−40 Screws

and Nuts

TLP 350CV or TLE 350

AC Power Module*

Blank AAPs

Pass-thru AAPs

2 Pos

AAP Shelf Bracket Kits

(2 brackets/kit)

3 Pos1 Pos

1A MAX

100-240V 50-60Hz

12 VDC, 1 A

Power Supply

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Included Parts

1Before connecting the TLP 350CV to a power source, refer to the TLP 350CV user guide, which is available at www.extron.com.TLP 350CV and TLE 350 • Se

Page 2 - Step 2 — Cut the Surface

2TLP 350CV and TLE 350 • Setup Guide (Continued)2Mounting the TLP 350CV and TLE 350Step 1 — Obtain Cut-out DimensionsATTENTION: • The table should b

Page 3 - Step 6 — AAP Assembly

3Step 3 — Run all CablesRun all cables necessary to support the AC connector, the cables stored in the cubby, and all planned AAP connectors. Run the

Page 4 - COMPUTER

4TLP 350CV and TLE 350 • Setup Guide (Continued)4Step 7 — Install the AAP Assembly1. From under the table, push the rst AAP assembly through the bo

Page 5 - Step 10 — Connect the Network

5Connecting the TLP 350CVNOTE: The rest of this guide applies only to the TLP 350CV (not to the TLE 350).The cable connections are located in a panel

Page 6

6TLP 350CV and TLE 350 • Setup Guide (Continued)Front Panel FeaturesWith the lid down, the screen, light sensor, and the illumination LED are disable

Page 7 - Initial Conguration

7Initial CongurationBefore use, congure the touchpanel, using the on-screen menus.1. Press the Menu button once (e in the gure on page 6). The Mai

Page 8 - GUI Design and Conguration

868-1692-50 Rev. C 04 13 88TLP 350CV and TLE 350 • Setup Guide (Continued)Extron Headquarters+1.800.633.9876 (Inside USA/Canada Only)Extron USA - W

Comments to this Manuals

No comments

Extron-electronics TLE 350 Setup Guide User Manual

Browse online or download User Manual for Hardware Extron-electronics TLE 350 Setup Guide. Extron Electronics TLE 350 Setup Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Extron-electronics TLE 350 Setup Guide