DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • HTML Operation 97
Control Tab
Set and View Ties Page
You can create ties on the Set and View Ties page (see figure 65). Access the Set and View
Ties page by clicking the Control tab.
Figure 65. Set and View Ties Page
The page consists of a matrix of input (rows) and output (columns) selection buttons of two
colors:
• Amber — indicate ties.
• Gray — indicate no ties.
Creating or deleting a tie
Make or break a tie as follows:
1. Move the mouse over the matrix of input and output selection buttons. Click a button to
• Create a pending tie of the input and output associated with that button
• Create a pending untie of the input and output associated with that button
A “P” (for pending) appears in the button (see figure 65 [
a
]).
NOTES:
• Because of command length limitations in the browser, you can make a
maximum of 30 connections with a single Take command (step 2).
• To tie an input to all outputs, click the input number for that input.
2. Click Take (
b
) to make the configuration changes or Cancel to abandon the
configuration changes.
Comments to this Manuals