Extron-electronics VN-Matrix 200 Series User Manual download pdf (Page 23)

17 IP forwarding By default, this parameter is set to 0. For normal operation,

there is no need to modify this setting. Setting a value 1 will

enable IP forwarding between the two network ports on the

device. This function is not required for normal operation of the

device.

8 Set the number of the port that is

used for communications with the

system controller.

By default this is set to 5432, and this may be changed if

required. Note that all VNC 200 units MUST have the same port

number assigned.

18 Set the port number that is used

for communication with the web

server.

By default this is set to 80, and this may be changed if required.

Note that the web browser in use must use the same port

number.

NOTE: Option 18 is only visible on the controller.

9 Reboot and activate settings. Reboot the VNC 200 to activate any changes made.

NOTE: Typing reboot at the HyperTerminal cursor will also

reset the unit.

NOTES:

• For advice on choosing IP addresses, see “Using the Ping Utility to Test

Communications”.

• For normal applications only Network Port 1 settings need to be configured.

• Options 1 and 11 are toggle action. For example, to switch between static and DCHP

modes simply type 1 <Enter>. The currently selected mode is the option listed first.

When DHCP mode is selected, options 2, 3, 4, and 5 (or 12, 13, 14, and 15) will not

be displayed.

• Only one VNC 200 may be configured as a controller (see below). The controller IP

(option 7) must be set to the IP address of the unit designated as the controller.

To configure a VNC 200 as a controller…

1. Ensure the boot method for Network Port 1 is set to static (option 1).

2. Set the IP address (option 2) and controller IP (option 7) to the same value.

To implement the new settings…

1. Once you have completed making any changes, type 9 <Enter> to exit the menu. The

VNC 200 will now reboot automatically to implement the new settings.

2. If the unit does not reboot for any reason or you want to perform a manual reboot,

type reboot <Enter> at the command prompt (or cycle the power off and on) to

reboot the unit and implement the new settings.

The VNC 200 is now ready for connection to the network.

VN-Matrix 200 Series • Installation 18

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 122 123

No comments

Extron-electronics VN-Matrix 200 Series User Manual Page 23