Extron-electronics DMS 1600_2000_3200_3600 User Guide User Manual Page 41
- Page / 121
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Operation 35
Performing a System Reset from the Front Panel
The front panel reset is identical to the
E
ZXXX
}
SIS command on page 56. A system
reset clears all ties and presets, all output mutes, and resets all I/O grouping.
Reset the switcher to the factory default settings by pressing and holding the View button
and Esc button simultaneously while you apply AC power to the switcher (see figure 24).
NOTES:
• For the reset to occur, you must apply power from an unpowered state. Applying
the redundant power with primary power already applied does not reset the
switcher.
• System reset does not reset the Internet protocol (IP) settings or replace
user-installed firmware.
CONTROL
T
ESCVIEW
RESET
REMOTE
RS-232/RS-422
LAN
BI-LEVEL
TRI-LEVEL
ACT LINK
100-240V 50/60Hz 1.2A MAX.
100-240V 50/60Hz 1.2A MAX.
REDUNDANT
PRIMARY
DISCONNECT BOTH POWER
CORDS BEFORE SERVICING
SWITCH
REFERENCE
13 - 16
Press and hold the buttons while
you apply power to the switcher.
— and —
Release the View and Esc buttons.
Power
The switcher flashes the
button indicators; light amber,
off, green, red, and amber;
and then turns them off.
Continue to hold the View and Esc
buttons until all input and output buttons
return to either unlit or to background
illumination.
Figure 24. Performing A System Reset
Background Illumination
The buttons on the front panel can be set to provide amber background illumination at
all times or the background illumination can be turned off. To toggle the background
illumination on or off, press and hold the Input 1 and Input 2 buttons simultaneously for
approximately 2 seconds (see figure 25).
1 2 3
16
Press and hold the buttons.
After approximately 2 seconds, release
the Input 1 and Input 2 buttons.
Figure 25. Locking the Front Panel
- User Guide 1
- DMS 1600, DMS 2000 1
- DMS 3200, and DMS 3600 1
- Safety Instructions 2
- FCC Class A Notice 3
- FDA/IEC 60825-1 Requirements 3
- Specifications Availability 4
- Contents 5
- Introduction 7
- DMS 3600 8
- Features 9
- Installation 12
- I/O Boards 15
- I/O connections 16
- Remote Port 17
- Ethernet Port 17
- Reset Button and LED 18
- DMS 2000 19
- Operation 20
- Input and Output Buttons 22
- Control Buttons 24
- Power Indicators 25
- 29 28 30 31 26
- Front Panel Operations 27
- Creating a Configuration 28
- 1 2 3 4 5 6 7 8 15 16 29
- 1 2 3 4 5 6 7 8 32
- I/O Grouping 33
- 1324Group # 34
- Press the button 40
- Background Illumination 41
- Rear Panel Operations 42
- • clears all output mutes 43
- • clears all I/O grouping 43
- Troubleshooting 45
- Digital Signal Guidelines 46
- Configuration Worksheets 47
- • Tied to the VCR (output 6) 48
- Input sources 49
- Preset # Title: 49
- 10 11 12 13 14 15 16123456789 49
- Output destinations 49
- Preset # 50
- Programming Guide 52
- Ethernet (LAN) Port 53
- Host-to-Switcher Instructions 54
- Switcher-Initiated Messages 54
- Switcher Error Responses 55
- Command ASCII Command 57
- Response 57
- Additional Description 57
- Additional description 65
- Matrix Software 67
- Starting the program 70
- Using the program 71
- IP Settings/Options Window 73
- Hardware Address field 74
- Use DHCP checkbox 74
- Sync Time to PC button 75
- Use Daylight Saving checkbox 75
- E-mail Addressee fields 77
- Updating Firmware 78
- Tools > Update firmware 80
- OK to continue 80
- Uploading HTML Files 82
- Windows Menus 83
- Tools menu 84
- Proper operation 85
- Component has failed 85
- Preferences menu 86
- Master-Reset selection 87
- Using Emulation Mode 88
- Using the Help System 88
- HTML Operation 91
- Status Tab 93
- Configuration Tab 95
- Date/Time Settings fields 97
- Passwords Page 98
- Email Settings Page 99
- Firmware Upgrade Page 100
- File Management Tab 102
- Control Tab 103
- EDID and Mute Settings Page 104
- Special Characters 105
- Modifications 106
- Maintenance and 106
- PRIMARY POWER SUPPLY 107
- REDUNDANT POWER SUPPLY 107
- (DMS 1600 and DMS 3600) 109
- Removing a Fan Module 110
- Installing a Fan Module 111
- Ethernet Connection 114
- Microsoft Telnet> 117
- Subnetting — A Primer 119
- Extron Warranty 121
Related products and manuals for Accessories for video Extron-electronics DMS 1600_2000_3200_3600 User Guide
(2 pages)© 2020, manymanuals.com. All rights reserved. | 1.947 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals