Extron-electronics DSC HD-3G A User Guide User Manual Page 12
- Page / 74
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
a AC power connector — Connect the supplied US standard IEC power cable
between this IEC connector and a 110-220 V 50-60 Hz AC power source. The front
panel control and input selection buttons light in sequence during power-up.
b Input connector —
• DSC 3G-HD A: Connect a 3G/HD/SD-SDI source to this female SDI BNC input
connector.
• DSC HD-3G A: Connect an HDMI source to this female HDMI input connector.
c Buffered loop-through connector — Connect a local monitor to this female SDI
BNC input connector. Buffered 3G/HD/SD-SDI signals are reclocked, reshaped, and
restored when passed through this loop-through connector.
d Genlock sync connectors (DSC HD-3G A only) —
Connect an external sync device to the female BNC input
(left) connector to sync the video signal in broadcast or
other sync-critical applications.
Connect any downstream equipment that requires
genlocking to the female BNC output connector (right) to
route the sync signal throughout the system in broadcast
or other sync-critical applications. Bi-level and tri-level sync
are supported.
e Audio input connector —
• DSC 3G-HD A: Connect audio from the source to this 5-pole captive screw
connector. Analog audio input can be embedded on the HDMI output. AES audio
that is embedded on the SDI input can be identified and one to four pairs (8
channels) of the available 16 channels can be embedded on the HDMI output:
• If eight-channel digital is selected, four of the eight available channel pairs are
used.
• If two-channel digital is selected, one of the eight pairs can be selected.
• DSC HD-3G A: If desired, connect analog audio input from the source to this
5-pole captive screw connector. HDMI or analog audio can be passed through to
the SDI outputs as AES pairs.
Unbalanced Stereo Input
Balanced Stereo Input
Tip
Ring
Tip
Ring
Slee
ves
Do not tin the wires!
Tip
Sleeve
Sleeve
Tip
LR
LR
inch (5 mm) MAX.
Figure 5. Wiring the Audio Input Connector
ATTENTION:
• The length of the exposed wires in the stripping process is critical. The ideal
length is 3/16 inch (5 mm). If the exposed portion is longer, the wires may
touch, causing a short circuit between them. If the exposed wires are shorter,
they can be easily pulled out, even if tightly fastened by the captive screws.
• Do not tin the wires. Tinned wire does not hold its shape and can become
loose over time.
• For unbalanced audio, connect the sleeves to the ground contact. Do not
connect them to negative (–) contacts.
SYNC
GENLOCK
Input
Output
DSC 3G-HD A and DSC HD-3G A • Installation 6
- User Guide 1
- DSC 3G-HD A and 1
- DSC HD-3G A 1
- Safety Instructions 2
- FCC Class A Notice 3
- Specifications Availability 4
- Contents 5
- Introduction 7
- Features 8
- Both Models 9
- SMX Series 10
- Matrix Swit 10
- Rear Panel 11
- Connections 11
- Do not tin the wires! 12
- Unbalanced Stereo Input 12
- Balanced Stereo Input 12
- Connecting for Remote Control 13
- Computer 14
- DSC Front Panel 14
- Operation 17
- arrow buttons 18
- On-screen Display 19
- OSD Menus — DSC 3G-HD A 20
- (H and V) 21
- Brightness 23
- Contrast 23
- Quick Setup submenu 24
- User Presets submenu 25
- Picture Controls submenu 28
- Input submenu 29
- Output Submenu — DSC 3G-HD A 31
- Output Submenu — DSC HD-3G A 33
- Audio Submenu 35
- SDI Audio 37
- 1 through 4) 37
- 1 or 2) 37
- Advanced submenu 38
- Communication Screen 40
- Device Info Screen 40
- Auto-Image 41
- C1: 720P @ 60 Hz 42
- Resetting the Output Rate 43
- Power Save Mode 44
- User Presets 45
- Input Presets 45
- Resetting 46
- Configuration and 47
- DSC-initiated Messages 48
- Error Responses 48
- Symbol Definitions 49
- X2) = Output resolution 50
- X2) = 11 through 92) 50
- X2! = 11 through 96) 51
- M SSAV } 52
- SsavM X4) ] (verbose mode) 52
- Scaling Converter 52
- Command ASCII Command 55
- Response 55
- Additional Description 55
- Input Configuration 55
- Picture Adjustments 56
- Input Preset Name 60
- Output Scaler Rate 60
- Audio Configuration 63
- Advanced Configuration 64
- button 66
- Windows-based Control Program 68
- FIG_download page 70
- Starting the Control Program 72
- Reference 73
- Information 73
- Contact Information 74
- Extron Warranty 74
Related products and manuals for Accessories for video Extron-electronics DSC HD-3G A User Guide
(2 pages)© 2020, manymanuals.com. All rights reserved. | 0.284 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals