Extron-electronics DVI 201 User Guide User Manual download pdf (Page 24)

Receiver input ports — Connect one end of the two separate TP cables from the

transmitter output connectors (item

on page 17) to these RJ-45 female connectors.

CAUTION: Do not connect this device to a computer data or telecommunications

network.

Connect the free ends of the same TP cables from the receiver to the female Output

RJ-45 connectors (item

on page 17) on the transmitter.

See TP cable termination to properly wire the RJ-45 connectors.

NOTES: • In order to ﬁt in the junction box, the TP cables and RJ-45 connectors

should not have a boot installed.

• Extron recommends 28AWG to 24AWG TP cable for the RJ-45

connectors.

• For resolutions of 1600x1200, 1920x1200, and 1080p, Extron strongly

recommends DTP26 cable, or equivalent.

• Connect transmitter output 1 to receiver input 1. Connect transmitter

output 2 to receiver input 2.

• If necessary, test for proper cable connection (output 1 to input 1,

output 2 to input 2) as follows:

1. Plug both TP cables into the powered unit.

2. Momentarily connect either of the cables on the opposite end into

the “2” connector on the unpowered unit.

If the Power LED on the unpowered unit is lit, the connection is

correct.

If the Power LED on the unpowered unit is not lit, unplug the

connector on the unpowered end and connect the other cable to

the “2” connector.

DVI Output connector — Connect a DVI display for the transmitted direct digital

image. See DVI connector pin assignments for pin assignments.

Audio Input connector (DVI 201 A D Rx [Decora] only) — Connect one end

of a 5-wire audio cable to this 3.5 mm, 5-pole direct insertion connector.

Connect the free end of the same cable to any compatibly wired audio source unit,

such as the output of a switcher or a DVI 201 A D Tx (Decora) transmitter (item

page 18).

Figure 19 shows how to wire the captive screw audio connector. Insert the wires into

the appropriate openings in the direct insertion connector. Tighten the screws on the

side to fasten the wires.

Tip

Sleeve

Tip

Unbalanced Input Balanced Input

Do not tin the wires!

Sleeve (s)

Tip

Ring

AUDIO

OUTPUT

AUDIO

OUTPUT

Figure 19. Captive Screw Connector Wiring for Receiver Audio Input

DC power input connector — Plug the included external 12 VDC power supply

into either this 2-pole connector or the power input connector on the transmitter

(item

on page 17). See Power supply wiring to wire the connector.

DVI 201 • Installation and Operation 20

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Comments to this Manuals

No comments

Extron-electronics DVI 201 User Guide User Manual Page 24

Comments to this Manuals

Related products and manuals for Accessories for video Extron-electronics DVI 201 User Guide